Pelar cable coaxial
Pelar el cable para colocarle el conector F es algo sencillo de hacer, pero la forma mas correcta seria la siguiente:
1. Cortamos el aislante exterior en una longitud aproximada de 12mm y echamos la malla normalmente de cobre o aluminio hacia atrás http://i79.photobucket.com/albums/j1...Jo/cable_1.jpg 2. Cortamos el aislante interior en aproximadamente unos 10mm http://i79.photobucket.com/albums/j1...Jo/cable_2.jpg 3. Enredamos la malla sobre el cable para evitar que al poner el conector F sobresalga por detrás del mismo http://i79.photobucket.com/albums/j1...Jo/cable_3.jpg 4. Enroscamos el conector F en el cable y cortamos el cobre interior de cable para que no sobresalga mas que 1mm de lo que es el propio conector F http://i79.photobucket.com/albums/j1...Jo/cable_4.jpghttp://i79.photobucket.com/albums/j1...Jo/cable_5.jpg NOTA: Es muy importante que no tengamos conexión entre malla y cable http://i79.photobucket.com/albums/j1...Jo/cable_6.jpg Saludos BoTi |
La franja horaria es GMT +2. Ahora son las 07:18. |
Powered por vBulletin™ Version 3.8.10
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.
Traducido por vBsoporte - vBulletin en español
ZackYFileS - Foros de Debate