Cita:
Iniciado por jubamo
It is very rare, the version she is correct, it detects impcode ok, single is to prove, that to my is past to me, to change jumper normal way, power on 15 seconds, power off,change jumper way debug and to prove again.
When it fails the Pracc is because not this the ALI CPU in the correct address of vector debug.
|
Set back the jumper to normal position, switched on, wait for 15 seconds, switched of, set jumper to debug, then tested again -> same results: init PrAcc ...
Then I tested then with /dma option: now init PrAcc is skipped and the flash has been read. First read dw= 00f000f0, all the following dws ar 00000000.
Jumper on the SMT-board is a little bit different. There is only one position: Jumper set = debug mode, Jumper remove= normal mode.
Jumper on the GMI-board (SL65...): The jumper connects a 10k resistor to gound in normal mode and a 10k resistor to +3.3 in debug mode.
But this shoudn't change anything.
Última edición por ottobald; 11/06/2007 a las 17:39.
|