Cita:
Iniciado por ghostrider
To Ottobald, I had the same problem as you, tried and tried, so what i did was shortend my jtag cable, made sure all wires were separated from each other and then use the following msdos string
wrt54g -flash:wholeflash /skipdetect /fc:1 /instrlen:5 /alienable
you can see that fc:1 was placed after skipdetect and not at the end as you have, as if i am not wrong msdos has its problems, and the way i think the program works is, that first it gets the flash file then it skips detection gets the flash type then does the installation procedure and last enables the ali chip.
Iam not a programmer so i could be wrong but that is how it worked for me on a windows XP amd 1.8
hope you get yours going
|
Finally I have managed to read out the flash via EJTAG. It wasn't the JTAG cable but there was a hardware fault in this unit. The "good" friend whom I got this receiver from modified someting in the voltage stabilizer 1.8V. The voltage was only 1.3V. After I had fixed this problem reading out via JTAG worked perfectly. Thanks to all the good friends here in this forum who helped me with hints, software, pictures and so on. Keep on going your excellent work......... |