contestacion de gigabyte: tam`poco funciona.
Thank you for emailing GIGABYTE.
We are delighted with your interest in our products.
Is there any changes in your system before it happens? Which pen driver have this problem? Is that possible test other pen driver?
On which PC this pen driver without problem.
You can try make a full reset about your system like below and see if there is still problem:
1) Turn off power.
2) Remove the power cord from the PSU and wait 30s.
3) Take out the battery gently and put it aside for about 5 minutes or longer. (Or you can use a metal object to connect the two pins in the battery holder to make them short-circuited.)
4) Re-insert the battery to the battery holder.
5) Now shortcircuit Clear CMOS jumper for 10 s.
6) Remove shortcircuit.
7) Connect power cord to PSU again and turn on power.
8) Power on your system.
9) If BIOS can POST, please enter the BIOS and load the optimal defaults setting.
10) Save changes and reboot the system.
Load Optimized Defaults. Check Time and date. Check SATA Mode setting. If you did set SATA Mode to RAID Mode before you did Clear CMOS, please set SATA Mode back to RAID. Finish bios setup with Save & Exit.
Regards
GIGABYTE Team
If you are satisfied with our service, please rate us.
If not, we would be pleased to receive constructive criticism in this way.
|